Reddit mentions of Bondo Home Solutions Wood Filler, Sandable in 15 min, 1.9 lbs with 1 oz Hardener

Okay so It's a pretty labor-intensive process, so be forewarned

I didn't want to just draw the parts by hand because I wanted the shield to be game accurate, so I took this picture and had it printed on a poster at my local staples, I used the largest poster size, so this was about $20. I then cut out the entire shield from the poster to draw the base, and cut out each of the detail pieces to trace.

I cut and sanded everything with a multi-use dremel. The wood that I used was 1/4 inch birch, which is easy to cut and sand. I got a big sheet at home depot, and I ended up only using half. (I might use the other half to make the Master Sword Scabbard later this year) I would recommend using 3/4 inch wood or layering more pieces than I did, because my shield doesn't have anywhere near as much depth as I would like.

So I cut out the smaller shield pieces for layering by tracing the large shield piece, then taking a 2-3 inch block of wood and running it around the inside edge of the first trace. I made sure the three pieces were centered on top of each other before supergluing them together.

I filled spaces on the layered shield with wood bondo, sanded that down as smooth as possible, then filled all the little holes with wood filler, of course you have to sand this too. Then I painted it with this, but you can use a lighter shade if you want a different look. Finally, I covered the whole thing in newspaper except for the little parts where the border shows through (the silver triangles) and I painted those silver.

For the border I cut the border out of the poster and traced it on the birch, cut it out with a dremel, then cut it into sections and sanded it down. I laid it down on top of shield base (after I had filled it in with the bondo) and filled the gaps between the border parts with bondo. What this does is reconnect the border pieces in a curved manner that perfectly fits on the base. When the bondo dries, add more bondo on the reverse side of the border to strengthen the connection. Then you can sand it down smooth. Spray paint that shit silver and you're good.

For the triforce, pointy decals, and bolts for the border, I cut them out of the poster, traced them onto particle board, cut them out and sanded them to look 3-dimensional. I painted them, and that's that.

Attach all the pieces together using wood caulk. The last step is adding Hylia's Crest, which was frustrating to figure out at first. What I ended up doing was cutting out the details from the poster, tracing them onto this and cutting them out. These decals were a little too pink for me, so I painted them with this glossy red paint. Finally I peeled off the backing and stuck them on the shield.

To hang it up, I pounded some small nails into the back and hung a metal wire between them.

Thanks for your interest. I'd be happy to answer any other questions you have!

That is not going to be strong enough. THIS is what you need - it's a two part polyvinyl product. If you are trying at Lowes, THIS or THIS would work.

I need to fill in door hinges and a door latch on the door frame from where I removed a door. Would this product work to fill the space? After which I would sand it down and then paint? Or do I need to cut a thin sliver to fit? The hinge is shallow.
https://www.amazon.com/Bondo-Home-Solutions-Wood-Filler/dp/B0007ZG9T4

obviously you have never heard of this amazing product. https://www.amazon.com/Bondo-Home-Solutions-Wood-Filler/dp/B0007ZG9T4/ref=zg_bs_383886011_3