Reddit mentions of Orion Motor Tech 1/4 Oz Wheel Balance Weights | Metal Silver & Self Adhesive - 120pc
Sentiment score: 0
Reddit mentions: 1
We found 1 Reddit mentions of Orion Motor Tech 1/4 Oz Wheel Balance Weights | Metal Silver & Self Adhesive - 120pc. Here are the top ones.
or
Made of steel, zinc and plastic coated, sturdy and anti-corrosionLead free, 1/4 oz wheel weights with adhesive backPerfect for balancing wheels12 Pieces of 1/4 Oz in a stripNot recommended for motorcycles
Specs:
I'm copying my post (again, slightly altered though) from another thread, so I am sorry for it being a little "generic." However, it does apply to the tires and 4ws without a new radio/transmitter for the Everest 10.
I have been using the Pro-Line Hyrax 2.2" G8 and love them. I will say I had great fun with the stock tires though. I ended up putting wheel weights in with the Hyrax tires. They are bigger than stock (fits fine on stock rim, will need to trim body slightly in rear) and I felt that I rolled easier. Possible higher center of gravity, but I didn't do anything specific to measure. So I added wheel weights and everything seems great now (albeit more stress on the other parts due to unsprung weight). These weights will stick to the rim (on the inside, not outside like real cars) and wrapped with some electrical tape they haven't budged. I've put them through a lot of water/mud and they're doing just fine. I used these weights because it was cheaper than alternative scale wheels weights, and I can add a lot more. Since the crawler is slow I'm not worried about how they imbalance the wheel.
Permanent 4 wheel steer parts needed. servo plate, side linkage, y harness reverser, servo linkage, servo. Of course part 5 (servo) can be whatever you choose. To make it non-full time 4 wheel steer you would need to do more research. I have not done it. I believe you need another transmitter to go with the 3 channel radio you would need.