#283 in Office electronics products
Use arrows to jump to the previous/next product
Reddit mentions of Printers Toner Transfer Paper 10 Sheets
Sentiment score: 1
Reddit mentions: 1
We found 1 Reddit mentions of Printers Toner Transfer Paper 10 Sheets. Here are the top ones.
Buying options
View on Amazon.comor
Manufacturer: Pulsar Product Category: Printers RoHS: No Product: Dry Transfer Graphics
Specs:
I think it would be much easier to buy either single sided or double sided copper plated FR4 boards to start with. I use this sugar based laser toner transfer paper. It's nice because you use a laminator to put it on and then when you dip it in water, it just dissolves and the paper backing falls off.
I think the paper is backed with plastic so I peel the back off of the paper too. Otherwise it gets dark like it's only getting wet from water soaking in around the edges.
https://www.amazon.com/Printers-TONER-TRANSFER-PAPER-SHEETS/dp/B00HKHZ1GO/ref=sr_1_6?keywords=transfer+paper+pcb&qid=1558071449&s=gateway&sr=8-6
After that etch as usual. I made .5mm pitch traces and spacing between and had about 50/50 success rates on a 25x50mm (1x2 inch) board. Make the traces as wide as you can make them at first. Even if you have to make footprints smaller than the traces themselves. That shit will work for sure. Then you can work on getting the traces thinner by not over etching and other variables like that.