Reddit mentions of uxcell 8mm OD 30mm Long Spiral Stamping Light Load Compression Mould Die Spring Yellow 10Pcs
Sentiment score: 0
Reddit mentions: 1
We found 1 Reddit mentions of uxcell 8mm OD 30mm Long Spiral Stamping Light Load Compression Mould Die Spring Yellow 10Pcs. Here are the top ones.
or
- Designs may vary to green vent and transparent nipple cover
- Accomplishes "Infant-Directed" feedings
- Positive feeding experiences - efficient, successful and safe
- Non-specialty feeding bottle design. Fully reusable system
- Helps decrease gassiness and burping with non-squeeze method
Features:
Specs:
| Height | 0.79 Inches |
| Length | 2.76 Inches |
| Width | 1.57 Inches |
Springs:
https://smile.amazon.com/gp/product/B07M7MP2FC/
They're longer than the originals, and much stiffer. We went from having to relevel every print to never touching it once we had it dialed in.
Mirror bed:
https://www.ikea.com/us/en/p/lots-mirror-39151700/
Replaced the glass bed with one of these. Huge improvement over the original bed, especially since it meant we could swap out build plates without touching the leveling. Just unclip, remove old plate, add new plate. Wash with dish soap and water, wipe down and air dry.
Tools and parts for Petsfang:
https://smile.amazon.com/gp/product/B07R1H3Z8X/
https://smile.amazon.com/gp/product/B07DXRNYNX/
https://smile.amazon.com/gp/product/B071WMHNG5/
These and whatever M screw set floats your budget are all you need to print and install the Petsfang.