#8,394 in Industrial & Scientific
Reddit mentions of 3D Printer Accessories Automatic Leveling Module Film Pressure Probe Type Auto-Leveling Sensor for E3D V6 MK8 Makerbot Nozzles(for Makerbot Nozzle)
Sentiment score: 0
Reddit mentions: 1
We found 1 Reddit mentions of 3D Printer Accessories Automatic Leveling Module Film Pressure Probe Type Auto-Leveling Sensor for E3D V6 MK8 Makerbot Nozzles(for Makerbot Nozzle). Here are the top ones.
Buying options
View on Amazon.comor
Easy to install, can be applied to different types of 3D printers. Plug and play, the default trigger distance is 0.1mmHigh precision, leveling adjust accuracy can be up to +/- 0.05mmThe average service life of the module is more than 500,000 timesCompatible with almost all the 3D printer motherboards in the current marketGood anti-interference ability, will not be affected by the platform material, ambient light, ambient temperature and humidity, etc
Specs:
Height | 0 Inches |
Length | 0 Inches |
Width | 0 Inches |
I strongly recommend going through
https://makerware.thingiverse.com/thing:2803527
about the new delta auto config routines in Marlin.
This nozzle-mounted bed sensor https://www.amazon.com/dp/B075FDFYC3 connected to the Z- end stop made it super easy to get a quick level and then go back and fix the frame assembly errors I had, minimizing bad geometry and corrective offsets.
G33 -> update firmware with Delta values -> G33 adjust top frame screws and end stops -> repeat until everything is near as possible to zero and very repeatable.