Reddit mentions of SOCKET,STD DIN,FEMALE,5PIN,PANEL MOUNT

Each wall, bottom and top was separately printed then glued with an epoxy. This was made with 6 separate prints using PLA plastics. Total print time was about 6 1/2 hours.

I used parts that I had from my last enail project over a year ago. I know there are superior components such as connectors (XLR), and PID controllers. However I haven't had any issues with these in over a year with thousands of hours on these components.

I went ahead and shared the model files here if you wish to start printing your own. Included are the STL models for slicing and Sketchup models if you want to modify your own.

List of parts used with this particular 3d model.

• 40A SSR Solid State Relay
  
• SOCKET,STD DIN,FEMALE,5PIN,PANEL MOUNT (Outlet)
  
• Dual Digital Display PID Temperature Controller (PID Controller)
  
• AC 15A/250V 20A/125V 3 Pin 2 Position ON/OFF Switch (Rocker Switch)
  
• Interpower 8301213 IEC 60320 C14 Power Inlet with Quick Disconnects (120VAC Power Outlet)
  
• Rean NYS322 5 Pin DIN Plug
  
  
  I suppose I will model different versions for different pid face plates and outlets as time goes on. Hopefully others will modify and share their version.
  
  Feedback suggestions are always welcome.
  
  Special thanks to /u/j4yt3x for his DIY write up.