Reddit mentions of Sterling Audio ST51 Large Diaphragm FET Condenser Microphone (Standard)

If you are recording vocals, and have access to phantom power on your interface, i'd highly suggest purchasing a condenser microphone.

You can pick up a Sterling Audio ST51 for under a hundred dollars, and you will get a much better recording than using a sm57 (an instrument mic) or a sm58 (a live dynamic vocal microphone)

Amazon Link

Also purchase a pop filter if you can afford it.

Hey people of r/audioengineering, I'm new to all this, but I've ended up with a Sterling Audio ST51 Condenser Microphone. I was thinking I would do some streaming with it, and possibly getting into amateur voice acting as well.

The only problem is, I'm a little confused on how to connect it to my PC. I know a more expensive proper set up would have both a pre-amp and audio interface, but I'm not looking to spend a whole lot of money here. I was wondering what should I buy to connect the mic to my computer fairly cheaply? I've looked into some mixers like the behringer Q802, and I found this which looks okay, but I'm not very confident about it. Thanks for any and all help with this.

I recommend that you buy a USB X-Fi Go! Creative Audio sound card and a small mixer with phantom power. All the USB mics I've used have been terrible. Some pre and an external sound card will do you good. Especially if you later decide to expand your recordings. It'll cost you $200 max.


http://www.amazon.com/Creative-Soundblaster-Audio-System-SB1290/dp/B0044DEDC0

http://www.amazon.com/Sterling-Audio-ST51-Diaphragm-Microphone/dp/B003OA1BUQ/ref=sr_1_1?s=electronics&ie=UTF8&qid=1331437866&sr=1-1


http://www.amazon.com/Behringer-Premium-8-Input-Compact-Silver/dp/B004O2P6EU/ref=sr_1_1?s=electronics&ie=UTF8&qid=1331437846&sr=1-1

I started with this guy which goes for around 60 bucks. Add in this mic though you can find much more budget mics, I got that used for 35 bucks at a Guitar Center. Some balanced XLR cables, probably 20 bucks of RCA cables and 8 dollars of RCA-f to TS-m plugs from ebay and one of these to eliminate the ground loop on my mixer since my house is old and has poor grounding, it gets rid of that hum. I spent around 150 bucks for rather boss audio. I have since upgraded to an audio interface and a bigger mixer, but the 802 was a wonderful buy.

Well start at the beginning. People notice high quality recordings. If you listen to your Pod on headphones, crappy mics then get compressed to crappy MP3s is tedious to listen to.

If there are 2 or you, plan on spending a couple hundred bucks to solve this.

I use Sterling ST-51 Condenser mics- You can generally get them on sale at Guitar Center for $70 bucks. Here is a link to amazon

After you get that you'll need two XLR cables
After that you'll need some sort if interface. I have never had more than four people on my podcast, but the nature of podcasting generally means you'll get good a production, go as big as you can early, someone somewhere will want to pay you to produce for them. It's better to have the flexibility out of the box then have to cluge around with shitty hardware. However if you're on a tight budget there are other things you can get. Audio to computer interfaces give you more flexibility because you can add things like music live during a recording from other devices, allow you to use Skype (which isn't obvious when you have high quality mics and interfaces) I trend toward Focusrite, they make Bad Ass equipment. The Scarlett series works well for me. They don't have a loop back feature, but if you get that far let me know and ill tell you how to do it for the cost of a $1 RCA cable.

You can get linear PCM recorders Here and Here for about the same money as an audio interface, so its your call. They put it all in one package, but in the long run I think you'll end up getting tired of moving large files to your software for editing. I use the Tascam DR-40 and give it to people who are traveling - it is STELLAR and less than anything else on the market, because its old. But it's record out of the box- Easy.

Now Software- Ive used pay versions of Cakewalk. Ive used Audacity, which is great but clunky. I have landed on Reaper. It is the most full featured, open, continually updated, solid, go to, piece of software you can find. They're not dumb, they let you download a fully functioning copy for free. Its Not hampered in anyway. If you don't buy a license then you have to sit through a click away every time it opens. Better yet, just try it for a while, then you will appreciate it and want to buy the $60 license for small business or home use. Brilliant in every way.

That set up will last you for years and give you virtually pro quality production capability.

TL;DR
Mics (and Cables) Sterling ST-51 or similar (less than $100 ea)
Audio interface ( Many in, Many out, USB 2, Focusrite or Tascam)
Software (There can only be one, Reaper, Hands down)


Edit: My pods are at Defensesecurity.org , Homeready.org and Renman24.com - if you listen to the first ones and then listen to the latest ones you'll notice my equipment improvement, and editing style change. Its a muscle, work it out and it'll get better.

Edit 2: spelling and links
Edit 3: Links again

I recommend downloading Reaper. It has unrestricted free trial and purchase is $60.

Interface: something like M-audio mobile pre will work.
You can often find package deals that come with an interface, mic, cables and headphones for a couple hundred bucks. Just make sure the interface has Phantom Power and an Instrument (Hi-z) input.

Any PC made in the last 4 years can handle audio production no problem.

Choose a mic based on your style. For hard rock/metal/punk, get a Dynamic Mic (such as a Shure SM57). For acoustic/lighter/prettier stuff, get a Large Diaphragm Condenser Mic (such as a Sterling ST51