#5,132 in Automotive
Use arrows to jump to the previous/next product
Reddit mentions of BikeMaster Seal Puller Kit (32-0225)
Sentiment score: 1
Reddit mentions: 1
We found 1 Reddit mentions of BikeMaster Seal Puller Kit (32-0225). Here are the top ones.
or
- Designed to remove oil seals without damaging the seal housing
- Puller base applies even pressure to pull the seal evenly
- Kit comes with two sets of pulling arms: 2-3/4 in. and 4-1/2 in.
- Convenient protective storage case included
Features:
Specs:
| Color | Chrome |
| Height | 1.5 Inches |
| Length | 9.9 Inches |
| Number of items | 1 |
| Width | 4.5 Inches |
DOS cycles also can find one if treats (or any local bicycle shop) doesn't have one.
I have and it's pretty straightforward but you'll need some tools if you plan on doing a full rebuild. A three jaw puller, a bolt type puller for the clutch wheel (and some bolts and fender washers), blind bearing puller, a seal puller like this is very helpful, and a 20 ton press making things rather easy. I'm obviously excluding the basics like sockets, wrenches, picks, snap ring pliers and a dead blow hammer.
That's assuming you're taking the case fully apart and replacing every gasket, bearing, and oil seal. If you are just going to replace the clutch/accelerator brushes and that oil seal and gasket you should only need a bolt type puller, oil seal puller, and a snap ring pliers (and wrenches/sockets).
If you haven't already count the teeth on your front sprocket (the gear the chain is on your engine) easiest way is to find the master link and disconnect it and take the chain off to see. If you have less than 13 you can swap that out for a higher top speed, 13 tooth drops right in and the 14 requires a small bit of material removal for it to drop in.