Reddit mentions of flashtree 2pcs USB Type-C Female Breakout Board 6 pins Out (2.54mm 100mils Pitch) CC SBU

Hey everyone! Not sure who's been reading my updates but heres another one about upcoming changes on the mod I'll be testing this Sunday as well as restating where I'm at. If you haven't read my last update then let me start there.
I have wired up in my back housing a usb type C breakout board and a rocker switch to my batteries to bypass the vita as the source of charging. The positive lead from the battery and the vita is interrupted and the switch is here. When you open the switch (off position) it isolates the batteries from the vita allowing them to charge safely wile removing the possibility of grounding though the vita and frying the device. This also acts like I'm physically pulling the battery without opening the device so thats a plus.
Now that recharging is possible without the vita as a limitation this mod is amazing! My only thought moving forward is lifetime on the batteries that are parallel. From research I shouldn't have too many issues as ive taken every step to make sure they are the same as well as physically checking voltages with multimeter before last solder job. With that said i have a large 8000mah battery coming in 10/11 that i will rig up on 10/13 and will let everone know how its working by next week!
I love the enthusiasm of some people who have tried this and say its not possible and dangerous BUT I haven't ruined a single battery or any parts of my vita yet by simply doing research on the current bottleneck and using knowledge I have in digital logic and circuitry to bypass the issue and address it! I will be making another post if this 8000mah battery works or not showing the wiring and explain again how it works.
Much love to the vita community!

All parts used (rocker was purchased at local shop so thats just matching specs)


Smart charger for directly charging battery without using the vita port
https://www.amazon.com/gp/aw/d/B07BFWHD7G?psc=1&ref=ppx_pop_mob_b_asin_title
USB type C Breakout board as direct charging port
https://www.amazon.com/gp/aw/d/B07PVBM4FT?psc=1&ref=ppx_pop_mob_b_asin_title
Rocker switch to break circuit when charging
https://www.amazon.com/Uxcell-a16121900ux0202-Position-Rocker-Switches/dp/B071NFKHV6/ref=mp_s_a_1_15?keywords=120v+rocker+mini&qid=1570722598&sr=8-15
USB type C Connector for charger cable
https://www.amazon.com/gp/aw/d/B01787LKDI?psc=1&ref=ppx_pop_mob_b_asin_title

I found something possibly good for this, a panel mount type C plug that goes to a cable. Maybe you could find an adapter for the other end or I'd just straight up cut the cable and take the wires I need. Pretty pricey to cut up tho.

Cablecc USB 3.1 Front Panel Header to USB-C Type-C Female Extension Cable 40cm with Panel Mount Screw https://www.amazon.com/dp/B0755DDD9B/ref=cm_sw_r_cp_apa_i_g90BDb6WDJ9AC


Or if you want to try to make something from a PCB:

flashtree 【2 pcs】 USB Type-C Type C Female Breakout Board 6 pins Out (2.54mm 100mils Pitch) https://www.amazon.com/dp/B07PVBM4FT/ref=cm_sw_r_cp_apa_i_id1BDb55JDGEV