Best furniture replacements parts according to Reddit
Reddit mentions of Regency Stiffener for 60" Table Tops
Sentiment score: 3
Reddit mentions: 6
We found 6 Reddit mentions of Regency Stiffener for 60" Table Tops. Here are the top ones.
- Adds reinforcement to training tables, desks and more
- Mounts easily to the underside of virtually any surface with just a few screws
- Metal V-Channel construction
- Suitable for tables and desks measuring 60-Inch long
- Backed by a 5-year limited manufacturer's warranty
Features:
Specs:
Color | Metal |
Height | 1 Inches |
Length | 46 Inches |
Number of items | 1 |
Weight | 2 Pounds |
Width | 2 Inches |
▼ More
#1 of 34
Or buy some stiffeners for the bottom of the table
You need what's called a "stretcher" or "stiffener."
Take the top piece off.
Place it on the ground, upside-down, and put a book or something under either end and put some weight in the middle, like your knee or something (but not enough so that it breaks. You just want it to flatten out, or bend just a little bit the other way). Then screw in the stiffener.
To be clear, one Alex Supporting Two Linnmons? Probably fine... Depends on which size Linnmon you choose and your equipment. Longest I have is 47" and it is pretty sturdy for the amount of weight I put on it, but I wouldn't want to sit on it or anything...
Worst case scenario add a third leg to each Linnmon next to the Alex, to prevent slipping and add additional support. Probably unnecessary, and can be added later if you notice a problem.
Someone else mentioned this, if you need more support
Good luck!
You could also just screw a couple of table stiffeners under it. It won't be visible, won't bump your legs into it, and much easier than mounting something from the wall to your desk.
Nice setup, wish i could use that case but roommates are too much of a hazard to go open frame.
Not sure if its the photo or not but looks like your desk is bowing a little, with a span like that you might want to add a center support leg or grab a table stiffener.
strut as in a structure support bolted under the countertop.
Can use something like this https://www.amazon.com/Regency-Stiffener-60-Table-Tops/dp/B01DOZDUEK.
I however used this since i had a old one lying around, just sanded it and repainted it to brown. drilled two holes at the end and bolted them to the underside of the Karlby. Length between the drawers is around 110cm.
https://www.amazon.com/Kapro-779-40-60-Spirit-Quality-24-Inch/dp/B00BQI00DW/ref=sr_1_99?crid=2ER6IGZONSLN6&keywords=level+tool&qid=1566402762&s=gateway&sprefix=levell%2Caps%2C315&sr=8-99