Reddit mentions of SE Stainless Steel Funnel for Flasks - HQ93

• Play around with the filters. You can put a filter on the bottom of the chamber, on top of the weed, take out the mouthpiece filter, etc. This will change up airflow and maybe keep the vape a little cleaner.
  
  
• I didn't like the dry herb pod that came with the vape. It definitely helps with the mess, but it reduces airflow so much that it drives me insane. I personally prefer a really open airflow, so your experience may differ. I like to throw a filter in the bottom of the chamber, pack some medium-ish ground weed on top (I tamp down pretty hard), and hit it that way.
  
  
• Take gentle sips so that you don't clog the mouthpiece filter. Big rips will suck the weed into the filter, blocking your airflow. Long, slow sips work best for the Flowermate.
  
  
• Lower temps = slower extraction, gentler vapor. Higher temps = faster extraction, harsher vapor. I start low and end high because my throat can't handle a fresh bowl on the red setting.
  
  
• Pack the bowl full or nearly full for optimal performance. You need to stir it between cycles for even extraction.
  
  
• Keep your mouthpiece filter clean. Run a cotton swab dipped in isopropyl alcohol over the filter whenever necessary.
  
  
• [There are stainless steel funnels you can get to make loading a lot easier] (https://www.amazon.com/SE-HQ93-Stainless-Funnel-Flasks/dp/B0044EGTGC/ref=sr_1_3?ie=UTF8&qid=1520708924&sr=8-3&keywords=flask+funnel)

https://www.amazon.com/SE-HQ93-Stainless-Funnel-Flasks/dp/B0044EGTGC

You can buy baicalin powder on Amazon. You can also buy olive leaf extract with at least standardized 15% oluropein (preferrably more) on Amazon as well.

You also want to turn the powders into a topical solution.

You will need:

• a glass bottle for essential oil with an eye dropper. You can get it on Amazon or ebay
  
• a graduated cylinder, and
  
• a funnel
  
  For the solutions, here's what I recommend:
  
  
• 50% ethanol or isopropyl alcohol
  
• 30% propylene glycol
  
• 20% distilled water
  
  For the baicalin solution, mix in 10mg per millilitre. So, if you have a container with 60ml, then you want to mix in 600mg. This creates a 1% solution of baicalin. If you want, you may increase the concentration of baicalin. Perhaps 20mg/ml for a 2% solution, or even 50mg/ml for a 5% solution.
  
  For oluropein, the rule of thumb is just mix in 10 capsules (unless you get pure powder).