#3,045 in Industrial & Scientific
Use arrows to jump to the previous/next product

Reddit mentions of ARCELI STM32F103C8T6 ARM STM32 Minimum System Development Board Module STM32F103C8T6 Core Learning Board for Arduino

Sentiment score: 1
Reddit mentions: 1

We found 1 Reddit mentions of ARCELI STM32F103C8T6 ARM STM32 Minimum System Development Board Module STM32F103C8T6 Core Learning Board for Arduino. Here are the top ones.

ARCELI STM32F103C8T6 ARM STM32 Minimum System Development Board Module STM32F103C8T6 Core Learning Board for Arduino
Buying options
View on Amazon.com
or
    Features:
  • Mineral based sunblock made with natural ingredients, vegan. Its active ingredient, Zinc Oxide, is considered the most effective sunscreen.
  • Physical sunscreen, doesn´t contain chemicals. 50 SPF High protection against UVA and UVB rays.
  • Recommended for outdoor sports (surf, running, cycling etc) High protection for sensitive areas like scars, spots, redness
  • Thick texture, warm it with the fingers or use a sponge. Light-colored (medium tone of skin). Water resistant for up to 80 minutes.
  • Coral reef safe (non-nano ingredients). Biodegradable. Made in Galicia, 50g (travel size)
Specs:
Related categories:

idea-bulb Interested in what Redditors like? Check out our Shuffle feature

Shuffle: random products popular on Reddit

Found 1 comment on ARCELI STM32F103C8T6 ARM STM32 Minimum System Development Board Module STM32F103C8T6 Core Learning Board for Arduino:

u/VR-Unclebob · 2 pointsr/ElectricScooters

I will be fine. Here is the workflow and tools should you need:

The documents say soldering but there is no need if you buy some pins for the ST-Link as clone motherboards have holes for the pins so that they are easy to flash.

Get ST-Link Get Pins

Put pins in ST-Link connectors

Plug ST-LINK into PC, set up ST-Link drivers and software

Download firmware needed to PC

Plug ST-Link leads into the correct holes on the clone board

Run the ST-Link software to flash the board

Done

Details are here for the whole thing including great firmware for heavier guys or for people faced with hills. Its the V9 firmware at the bottom of the page: https://rollerplausch.fandom.com/de/wiki/Pro_Dashboard_und_CFW_Installation

Here is the link for flashing the board with an ST-Link (follow the Pro guide): https://www.instructables.com/id/Firmware-Downgrade-M365/

And here is a link to a guy who did what I did https://scootertalk.org/viewtopic.php?t=2600

Here is the ST-Link I used https://www.amazon.co.uk/gp/product/B079128QP1/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1

And here are the pins I used https://www.amazon.co.uk/gp/product/B077MJKCVT/ref=ppx_yo_dt_b_asin_title_o05_s01?ie=UTF8&psc=1

Good luck if you use the CW Firmware hills are a problem no more!