#18 in Temperature & humidity measurement tools
Use arrows to jump to the previous/next product
Reddit mentions of bayite Temperature Controller 1650W BTC211 Digital Outlet Thermostat, Pre-Wired, 2 Stage Heating and Cooling Mode, 110V - 240V 15A
Sentiment score: 5
Reddit mentions: 10
We found 10 Reddit mentions of bayite Temperature Controller 1650W BTC211 Digital Outlet Thermostat, Pre-Wired, 2 Stage Heating and Cooling Mode, 110V - 240V 15A. Here are the top ones.
or
- Simplified Design---Plug and play, easy to set. Support °C/°F display.
- Dual Relay Output---Be able to connect with cooling and heating equipment at the same time. Maximum output load: 1650W(110V)
- Dual Display Window---Be able to display real-time temperature and set temperature at the same time.
- Safe Protection---High and low temperature alarms are available when the temperature overshoots your desired temperature. Compressor delay protection time setting and Temperature calibration
- Warranty---1 year warranty for replacement or full refund without return. Comes with a 3m(9.8ft) waterproof probe sensor. Measure range is -58 ~ 230°F(-50 ~ 110°C)
Features:
Specs:
| Weight | 1.41 Pounds |
https://www.amazon.com/gp/product/B01KMA6EAM/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1
If you get the oil filled radiator and need an outlet turns on and off at different temps, this is one option. I used this all winter and it worked well. You set it to say, turn on at 34 and off at 40. I use the other outlet (which turns on if it gets too warm) to control a fan that helps make the most of the vents on the greenhouse.
I just got this from amazon today. I gave it a test run with the minifridge I'm converting and it worked nicely. And I went with this humidity controller
Just don't chop until you know you can completely control your conditions/environment for the next 7ish days. Humidifier/heater/AC/dehuey, etc. Make sure the weather doesn't make shit difficult for you, and if it does, get the right equipment running.
I'm drying right now and it's 80F outside. Got an AC pumping and a humidifier humming. Earlier this week had a space heat on since it was colder. Just gotta keep shit in check.
I'm aiming for 65-70F and 55-60% humidity for 7-10 days.
This Temperature controller is a life saver for me: https://www.amazon.com/gp/product/B01KMA6EAM/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
You plug in your heater and AC, and set the temperature points and the swing and you're off. If it gets below 63, my heater comes on, if it gets above 68, my AC comes on. All automated. Easily customizable.
Gotcha... I'd recommend checking the FG next time. Otherwise, you have no way of knowing how your yeast performed.
If you're fermenting in a colder than ideal environment, I'd recommend a temperature controller (like this one) and a cheap heating pad for your fermenter, especially if the temperature swings a lot. If possible, put the fermenter in an old sleeping bag with the heating pad, so it'll work a lot less to keep it warm.
I run my space heater outside the tent and just put it in front of a 6" flex duct that goes into the bottom of the tent with some pantyhose over the end to keep pests out. That duct is the only way fresh air can enter. I have the heater hooked up to one of these which has a sensor inside the tent and tells the heater when to turn on/off. Works really well.
Look online for Temperature Controller, it's a grounded outlet connected to a temperature controller with a temperature probe. Sort of like this.
This was the entire set up I bought and it's working very well.
You might do fine with just one light instead of three.
One of these: $79.99
Roleadro LED Grow Light, Galaxyhydro Series 300W Indoor Plant Grow Lights Full Spectrum with UV&IR for Veg and Flower
https://www.amazon.com/gp/product/B00PH1MQV8/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1
Two of these: $69.99
Roleadro Upgrade and Newly Developed LED Grow Light Full Spectrum 2nd Generation Series 300w Plants Light
https://www.amazon.com/gp/product/B01HI3AFYM/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1
VIVOSUN Durable Waterproof Seedling Heat Mat Warm Hydroponic Heating Pad 48" x 20.75"
https://www.amazon.com/gp/product/B01EMXI6VA/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1
$53.99
Bayite Temperature Controller
https://www.amazon.com/gp/product/B01KMA6EAM/ref=oh_aui_detailpage_o04_s00?ie=UTF8&psc=1
i would like to build an air conditioning system like that. what air conditioner do you use? does the air conditioner go back to its settings when it turns back on? can you provide a link to the black box and can you provide a link to the air conditioner. i found this on on amazon
is this the one u used?
edit: this one is rated for more amps
I bught this looks to be about the same thing
bayite Temperature Controller 1650W BTC211 Digital Outlet Thermostat, Pre-Wired, 2 Stage Heating and Cooling Mode, 110V - 240V 15A https://www.amazon.com/dp/B01KMA6EAM/ref=cm_sw_r_cp_apa_i_CjK2CbQ8PN8XZ
Maybe something like this would help. I use this in both of my greenhouses. Heat side activates when temperature drops a set amount below a set point (which you can vary) and cooling side activates when temperature rises a set amount above a set point.
https://www.amazon.com/bayite-Temperature-Controller-Thermostat-Pre-wired/dp/B01KMA6EAM/ref=sr_1_1?keywords=bayite+Temperature+Controller+1650W+BTC211+Digital+Outlet+Thermostat%2C+Pre-Wired%2C+2+Stage+Heating+and+Cooling+Mode%2C+110V+-+240V+15A&qid=1567183786&s=industrial&sr=1-1