#15 in Lighting low voltage transformers
Use arrows to jump to the previous/next product
Reddit mentions of BINZET 12V 2A Power Adapter, AC to DC, 2.1mm X 5.5mm Plug, Regulated 12v 2a Power Supply Wall Plug for LED Copper String Light, LED Strip Light
Sentiment score: 1
Reddit mentions: 1
We found 1 Reddit mentions of BINZET 12V 2A Power Adapter, AC to DC, 2.1mm X 5.5mm Plug, Regulated 12v 2a Power Supply Wall Plug for LED Copper String Light, LED Strip Light. Here are the top ones.
or
- Quality adapter with good electrical conductivity and long performance life
- Light weight and compact design. Great for different indoor uses
- Multiple protections against over heat, over current, over voltage and short circuit; safe and reliable to use
- Includes output cable with a standard 5.5 x 2.1mm DC jack for connection of LED strip, controller or dimmer
- Easier installation, save time and provide secure cable connection
Features:
Specs:
| Color | 12V 2A 24W |
| Height | 1.77165 Inches |
| Length | 3.1496 Inches |
| Width | 1.1811 Inches |
This will probably work for you:
http://www.rfcontrolsystem.com/index.php?main_page=product_info&cPath=470&products_id=579
In the manual it doesn't fully tell you where to put the power leads. Hook it up like in the youtube video linked by the other guy. If the directions are backwards, reverse the motor. Red is + and black is -.
You will need a 12 V DC power supply. Often called wall warts or wall plugs. You can get one on Amazon, Fry's, Best Buy, etc. Here's the first one I found, I have no idea about whether it's a good brand or good price or anything. Read the reviews. It's a 2 Amp which exceeds the minimum I calculated earlier, but you could go for a 3 amp as well:
http://www.amazon.com/BINZET-Adapter-Regulated-Supply-Copper/dp/B00PJZQDDO/ref=sr_1_1?s=electronics&ie=UTF8&qid=1457316150&sr=1-1&keywords=12+V+wall+plug
You will need the little plug that take DC power as input and outputs a red and black wire. Here's an example:
http://www.amazon.com/5-5mm-2-1mm-Female-Connector-Camera/dp/B005CMP434/ref=cm_cr_dp_asin_lnk
You will also need wire to go from the plug to the board, and since there are multiple points on the board to connect to +12V and 0V, you will need jumper wires to spread to multiple terminals like she does in the video. So you need something like this.
Finally to cut and strip the insulation from the wires you will need something like this.