Reddit mentions of Cablelera Power Cord Extension and Splitter, NEMA 5-15P to NEMA 5-15R x 2, 16 AWG, 13A, 125V (ZWACPQAG-14)

That still required cutting a cord and connecting wires.

Even safer would be something like this and a wall wart.

Cablelera Power Cord Extension and Splitter, NEMA 5-15P to NEMA 5-15R x 2, 16 AWG, 13A, 125V (ZWACPQAG-14) https://www.amazon.com/dp/B00FRODUR4/ref=cm_sw_r_cp_apa_i_6D3IDbQ0RZ31Q

The relay will probably also require wire connections though so...

Mains is no joke. Please be careful.

I don't understand the power tower, why not add a simple power cord splitter when you need the extra socket, and a modern USB charging station with enough oomph.

Is there a particular reason you want to charge the phone through the pack? I would just use a simple splitter like this.

It’s best to use a wall outlet something like this splitter would help

You really should not be using any heat sources that are not connected to a thermostat.

Unless your enclosure is located in a room with very, very good climate control (air conditioning, heating, and we're talking laboratory-grade), or you live in an equatorial country, as the seasons and weather change you are looking at 20 degrees of heat variation. As the weather changes, the temperatures inside the enclosure might reach unsafe levels; without a thermostat, as the room temperature changes, the enclosure temperature changes with it.

Instead, make sure each heating element is connected to a thermostat. Make sure each element is powerful enough (has enough wattage), and use the thermostat to fine-tune the temperature. When done this way, you can set the temperature and basically never need to worry about it. Even a particularly hot or cold day, the enclosure will still be at safe temperatures.

For your size enclosure I recommend at least 100W for the basking bulb. The wattage on your infrared bulb is fine.

For the thermostat, I strongly recommend the Herpstat line of thermostats. Using the Herpstat 2, plug your basking lamp/UV into line 1 (you'll need a power cable splitter), and your night lamp into line 2. Or, use a Herpstat 3 and plug all elements into their own line. All Herpstat thermostats can be programmed with a day/night cycle and can power up to 500W per line.

Someone asked the same question above, so I just copied and paste the answer below. Also, consider getting a small extension cord, like one of these:

https://www.amazon.com/Monoprice-105297-16AWG-Power-Extension/dp/B006VK7X1C/ref=sr_1_3?ie=UTF8&qid=1542440284&sr=8-3&keywords=short+extension+cord

https://www.amazon.com/Cablelera-Power-Extension-Splitter-ZWACPQAG-14/dp/B00FRODUR4/ref=sr_1_9?ie=UTF8&qid=1542440284&sr=8-9&keywords=short+extension+cord,


Product Height 2.5 inches

Product Width 1.4 inches

Product Depth 5 inches

Product Weight 0.35 pounds