#8,892 in Tools & Home Improvement
Use arrows to jump to the previous/next product
Reddit mentions of JACKYLED RGB 5050 3528 LED Light Strip Connector 4 Pins 10 mm Wide Strip to Strip Jumper 10-Pack Wire Solderless
Sentiment score: 1
Reddit mentions: 2
We found 2 Reddit mentions of JACKYLED RGB 5050 3528 LED Light Strip Connector 4 Pins 10 mm Wide Strip to Strip Jumper 10-Pack Wire Solderless. Here are the top ones.
or
- Feel free to bend it: Our 5050 4 pin led connectors with 17 strand tin-plated oxygen-free copper inside each circuit, the wires are thicker than most of the other rgb led strip jumper in the market, features stronger physical features. These led light strips connectors are flexible and durable enough for bending or twisting in any angles without breaking.
- Easy to use: Just clasp your prepared led strip section into the led 4 pin connectors to get connected. Make sure the strip is properly aligned with the connector(match the positive terminals). If you need to solder it with light strip cable, you had better use less tin in order to avoid short circuit.
- Strong Compatibility: Compatible with all 4 pins 5050 RGB LED Strip and 3528 LED Light Strip; compatible with both waterproof and non-waterproof light strips; works with dimmable strip lights.
- Solid & Effective Connection: One of the cable end contacts of our led strip lights connectors were soldered already, the other side contacts are open to stick in. And 2 pcs L-shape corner connectors are included for your varied needs.
- Note: These led jumpers are only suitable for 10mm (0.39in) wide 4 pin RGB led light strips. If you have any issues, inquiries, or need assistance, please feel free to contact us directly.
Features:
Specs:
| Color | Rgb (Red, Green, Blue) |
| Size | RGB 10-pack |
| Weight | 0.13 Pounds |
I bought these strip lights - LED Strip Lights, ATTUOSUN... https://www.amazon.com/dp/B07P61XM9J?ref=ppx_pop_mob_ap_share
And these connectors - JACKYLED RGB 5050 3528 LED Light... https://www.amazon.com/dp/B072KRCJLD?ref=ppx_pop_mob_ap_share
I just ran them up the sides and over and drilled a hole in the bottom for the cables.
The adhesive is super sticky though, had to redo a small section and needed to use rubbing alcohol to get the adhesive off the glass.
Sure. You will need to purchase a power supply (this one is 12 volt) to drive this controller. So figure out if your strips are either 12 or 24 volt. If they happen to be 24 volt, this controller has a built in power supply for 24 volt LED strips only. Both can be added to the Philips Hue Bridge.
As for connections, I used these for RGB strips and these for power connections.
​
​