#4,465 in Automotive
Use arrows to jump to the previous/next product
Reddit mentions of Kohree 12-Way 12V Blade Fuse Block, 12 Volt Automotive Fuse Box Holder Waterproof with Negative Bus 5A 10A 15A 20A Fuse Panel LED Indicator for Auto, RV, Car, Boat, Marine, Truck
Sentiment score: 1
Reddit mentions: 1
We found 1 Reddit mentions of Kohree 12-Way 12V Blade Fuse Block, 12 Volt Automotive Fuse Box Holder Waterproof with Negative Bus 5A 10A 15A 20A Fuse Panel LED Indicator for Auto, RV, Car, Boat, Marine, Truck. Here are the top ones.
or
- Safe LED Indicator Design-- This blade fuse block comes with 12 fuse pieces and each circuit has its own led indicator light. When a fuse blow, the corresponding indicator light will light up instantly, so you can easily figure out the short circuit or any other fault and effortlessly fix the error.
- High Quality & Safety Material -- Made of environment friendly PBT material, IP86, CE Certification, blade fuse box is mechanically strong, heat and flame resistant and help you get rid of problems like broken, deformation, combustion or short circuit.
- Waterproof Neat Panel Mount--Clear PC cover, splash and dust resistant construction can add extra protection for your fuse box. It is easy to operate.
- Wide application-- Coming with multi-function DIY stickers to meet all your specific demands, convenient for examination and repair. Widely used in cars, marines, tankers, boats, rv, truck, moto homes,suv, yacht, ships etc.
- Optimal Conductivity & Best Service 12-circuit ATC/ATO/ATF blades fuse block,meeting all standards of an ideal fuse box. If you have any problem with this product, please feel free to contact us. We are always ready to help.
Features:
Specs:
| Color | Black |
| Height | 1.41732 Inches |
| Length | 3.34645 Inches |
| Number of items | 1 |
| Size | 12-Way |
| Width | 5.43306 Inches |
In larger projects where you are going to have to split a large supply into several separated runs you'll want to fuse each run independently. If you ar going to run 40A from a 60A power supply for instance, like others have suggested below it's best to run a few wires at for instance 10A.
Although it's not 100% accurate, power will take the way of the least resistance so if you lay down several wires next to your LED strip, the higher amount of copper and lower amount of resistance on those wires to the specific spots will automatically "distribute" the power among the available paths.
Always fuse below the rating of the wire (and if possible the end device), so if the wire is rated up to 15A for instance, fusing for 10A is a good idea that way, whatever happens it can never go up in smoke and cause a fire.
Since we are talking low voltage, car parts are easily available and cheap. For just a few links you could use one of these blocks: https://www.amazon.com/Support-Truck-Circuit-Standard-Holder/dp/B012CQEPN2 but if the project is a bit more complex or high amount of wires and Amps are used, these distribution blocks make your life a whole lot easier!: https://www.amazon.com/Kohree-Automotive-Waterproof-Negative-Indicator/dp/B07S99H25W Those are really excellent to work with, you can get them in 6 or 12 way variants and they take cheap car fuses which are available in lots of different values.