#13 in Electrical wall plates & accessories
Use arrows to jump to the previous/next product
Reddit mentions of Legrand - Pass & Seymour TV1LVKITWCC2 Recessed Television Receptacle Box One Gang Low Voltage Kit Easy Install
Sentiment score: 1
Reddit mentions: 2
We found 2 Reddit mentions of Legrand - Pass & Seymour TV1LVKITWCC2 Recessed Television Receptacle Box One Gang Low Voltage Kit Easy Install. Here are the top ones.
Buying options
View on Amazon.comor
INSTALLS IN EXISTING WALL SURFACES: Ideal for flat-screen TVs, home office, kitchen countertops and behind furniture to allow snug-to-wall placementCLEAN, FLUSH-MOUNT APPEARANCE: One-piece box / frame design; snap-on end caps hide mounting screwsFLEXIBLE CONFIGURATION: Position either line voltage or low voltage in all three openingsSecures plugs and multimedia connections stay behind the wall surface; a single cable can connect the source to componentsMolded-in template and rectangular cut-outAccepts standard Pass & Seymour Trademaster wall platesMetal swing brackets ensure a solid mountingUses old-work-style boxes for line voltagePass-thru brush strap permits low-voltage cables while keeping out dust and draftsDoes not require low-voltage terminations
Specs:
We just got done renovating our entire first floor and a lot of things I did myself so I had the opportunity to plan things out and pre-run wires.
For the Play:3, I purchased this receptacle box which holds an electrical outlet and has a small brush plate for low voltage. Had the electrician run the wire for an outlet and I ran the Cat 5 to it. You can see the box to the left of the Play:3 in this photo. Here's a closeup.
For the TV, it's the same concept as the Play:3. I used this recessed TV mount which has four available openings. I've got an electrical outlet and a brush plate in the two bottom openings.
Cable box, ethernet switch, and IR blaster are in the basement. HDMI, Cat 5, and IR receiver wires run from the basement, up through the wall, to the recessed mount. The Playbar's wires are snaked in the wall to the TV mount and through the brush plate. Not exactly to code, but it works. Here's a photo with the TV pulled out where you can see the mount and wires (not winning any /r/cableporn awards).
I've used something like the link below with a standard surge protected outlet (fits whatever outlet you want). Also allows the pass-thru for low voltage, like HDMI on the other side
Legrand - Pass & Seymour TV1LVKITWCC2 Recessed Television Receptacle Box One Gang Low Voltage Kit Easy Install https://www.amazon.com/dp/B009VYDHCY/ref=cm_sw_r_cp_apa_i_tUEPDb8QJA2PE