#8,570 in Smartphones and accessories
Reddit mentions of Adafruit 328 Battery, Lithium Ion Polymer, 3.7V, 2500mAh, 2" x 2.55" x 0.30" Size
Sentiment score: 0
Reddit mentions: 4
We found 4 Reddit mentions of Adafruit 328 Battery, Lithium Ion Polymer, 3.7V, 2500mAh, 2" x 2.55" x 0.30" Size. Here are the top ones.
or
- Size: 2" x 2.55" x 0.30"
- Output: 2500Mah at 3.7V nominal
- Output connector: jst wire to board (2Mm pitch)
- Compatibility: feather huzzah with Esp8266 wifi and feather huzzah with Esp8266 wifi starter kits. Polarity matches all Adafruit LiPoly/LiIon chargers and boards, other brands may have reverse polarity and can destroy your battery. As with all Lithium ion polymer batteries and with any power source - they should be used by experts who are comfortable working with power supplies.
- Not compatible with PS4 (Does not fit in controller).
Features:
Specs:
| Height | 0.31496 Inches |
| Length | 2.00787 Inches |
| Number of items | 1 |
| Weight | 0.11464037624 Pounds |
| Width | 2.55905 Inches |
No, the battery is not the best. You can upgrade it with a 3.7v battery like this for a much higher capacity -
https://www.amazon.com/gp/product/B01NAX9XYG/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1
However, note that you will have to switch the red and black wires in the housing for it to work (not difficult and requires zero tech knowledge, just a hair/safety pin). Before I would lose a bar or two of power each play session. With this battery I haven't charged it the past 3 times I've used it and it still has two bars.
I haven't noticed any input delay, which is amazing imo.
The antenna has a spot on the board that it plugs into. I don't think that's on a normal brook.
This is the battery. You will have to cut parts of the inside out and sand it down a bit to fit. It's tight, but it will fit! Oh, and the connector is not the correct size. I just stole the connector from the old battery tho, easy solder job.
https://www.amazon.com/gp/product/B01NAX9XYG/ref=oh_aui_detailpage_o06_s00?ie=UTF8&psc=1
Sorry. I should have said “extremely low frame rate” instead of “slideshow”.
Power source should be good, I thought. From the wall, I’ve got a CanaKit 5V 2.5A. That plugs into a Powerboost 1000c which powers the pi zero w from a beefy 3.7V, 2500mAh lithium ion battery. That should be enough juice, right?
I even took it apparent and got some fans on it to confirm it wasn’t an over-heating issue. I’m just worried it something wrong with the display. I’m gonna fiddle with those config settings they had me add and I’ll try hdmi_safe. It’s gonna be something obvious, I’m sure. Just need to figure it out.
Thanks again, btw, for all your help. Really, it’s made my life so much easier. The worst part of a project, though, is final assembly and having everything ALMOST working.
Will this power the Pi3?
https://smile.amazon.com/Adafruit-328-Battery-Lithium-Polymer/dp/B01NAX9XYG/ref=pd_ybh_a_1?_encoding=UTF8&psc=1&refRID=SW3EDRFKQECF9GWQAY53