#1,764 in Toys & Games
Use arrows to jump to the previous/next product
Reddit mentions of iFlight 150mm 2.4G Receiver Antenna Generation 4 RF113 (Smaller) IPEX Port for Latest FrSky X4R-SB Receiver and Remote Controller (Pack of 20pcs)
Sentiment score: 2
Reddit mentions: 4
We found 4 Reddit mentions of iFlight 150mm 2.4G Receiver Antenna Generation 4 RF113 (Smaller) IPEX Port for Latest FrSky X4R-SB Receiver and Remote Controller (Pack of 20pcs). Here are the top ones.
or
- 50K weight differential oil
- Traxxas performance differential oils make it easy to increase or decrease the limited slip action of the gear differential
- Altering the limited slip capability can enhance turning performance for faster exit speeds
- Higher weights result in more differential locking action
- Use Traxxas stock and hop-up replacement parts to get the most out of your Traxxas RTR vehicles
Features:
Specs:
| Height | 5 Inches |
| Length | 5 Inches |
| Weight | 0.01 Pounds |
| Width | 5 Inches |
I've moved away from dipole on my micro quads and I'm using these instead I cut off the connector, solder the ground and signal wire, then cut the element down to 12.922mm or as close as I can get. They still work great, and with the reduced weight, it's a lot less stress on the connection. They're nice and cheap too.
Amazon
iFlight 150mm 2.4G Receiver Antenna Generation 4 RF113 (smaller) IPEX Port for Latest FrSky X4R-SB Receiver and Remote Controller (pack of 20pcs) https://www.amazon.com/dp/B06XGD445X/ref=cm_sw_r_cp_apa_i_BXl0Cb7P08X5Q
Those just use an ipex connector yeah?
This should do it if so https://www.amazon.com/iFlight-Receiver-Antenna-Generation-Controller/dp/B06XGD445X
Can anyone tell me what size Ipex connector is used on the receiver of the FrSky Eachine Lizard95? I bought this set of antennas on Amazon thinking they were the correct ones:
https://www.amazon.com/dp/B06XGD445X/
But it was immediately apparent they were a noticeably larger Ipex connector. When I tried to put them on they could be wiggled right off with next to no force. Nowhere near the strength (and snap) of the original antenna.
Can anyone point me in the right direction? I was hoping to use Amazon prime so I can get back in the air faster, but at this point I'll take any vendor that ships from the US if the price is fair.