Reddit mentions of IRWIN 2078316 VISE-GRIP Wire Stripping Tool/Wire Cutter, 6"

You would definitely need speaker wire (and wire stripper tool) to connect the Miccas to the amp, and then either an aux cable or an aux-to-rca Y-cable to connect the amp to your source (laptop, phone, etc.)

• Wire Stripper
  
• Speaker Wire
  
• Aux Cable
  
  Hope this helps
  

Just get a short spool of some 16 gauge wire from Home Depot or whatever the budget brands are at your local electronics store. Cheapest brand will do, especially if you're just testing. I think Amazon makes their own speaker wire as well.


You'll need a wire stripper like this.


Just strip off 1/4" of the insulation from each side using the "AWG" number of your wire (16 if you bought 16 gauge). Twist the coper and put them in the binding post of your receiver and speakers. Connect black to black, red to red... etc. And you're all good.

Sorry for the late reply. First of all, take all of this with a grain of salt. This is my first build, so I am by no means an expert. You should definitely look in to all this on your own rather than blindly trust my purchases.
Here are the tools I got in my Amazon order:

• Wire Stripper
  
• No Clean Flux Paste
  
• XT60 Connectors
  
• 60/40 Rosin Core Solder
  
• Loctite Threadlocker 242 (blue)
  
• Weller 40 Watt soldering station
  
• Solder tip cleaner
  
• Helping hand with LED
  
• Bullet connectors
  
• Liquid electrical tape
  
• Heatshrink variety pack
  
• Chisel tip for soldering iron
  
• Servo cables
  
• 12/14/16 AWG silicone wire
  
• Zip ties
  
  I hope this helps.