#1 in Compressionunion straights
Use arrows to jump to the previous/next product
Reddit mentions of Parker CPI 4-2 FBZ-B Brass Compression Tube Fitting, Adapter, Tube OD x NPT Male
Sentiment score: 1
Reddit mentions: 1
We found 1 Reddit mentions of Parker CPI 4-2 FBZ-B Brass Compression Tube Fitting, Adapter, Tube OD x NPT Male. Here are the top ones.
or
- Adapter for connecting pipes or fittings of different types
- Fitting connects to tubing on one end and has an NPT male connector on the other
- Brass for corrosion resistance, ductility at high temperatures, and low magnetic permeability
- Single ferrule compression fitting has fewer possible leak paths than twin ferrule fittings
- For use with copper pipe and tubing
Features:
Specs:
Yes the pump is for wort into the chiller. You could probably gravity feed it if the kettle was above the chiller. You also have to run santizer through the chiller before chilling, so the pump makes that easier.
I bought some cheap 14 gauge wire to wrap around the tube, it's just to maximize water-copper contact which helps a lot with cooler.
For the fittings I bought the following, for each end:
1/4 female tee
1/2" barb x 1/4 NPT x2
1/4 x 1/4 compression fitting
Easiest thing to do it just go to a local hardware store, start with a 1/4" x 10ft copper tube in your hand then start looking at the brass fittings and piece it together in front of you. How you attach it to your sink will depend on your faucet, I had to mcgyver a stupid reducer and hose clamp setup. Most hardware store reps could help you piece it all together if you have a photo and know your faucet size.