Reddit mentions of SCStyle 5 Meters GT2 2mm Pitch 6mm Wide Timing Belt for 3D Printer CNC

I just ordered this. https://www.amazon.com/dp/B00F2IQNX8/ref=cm_sw_r_cp_apa_BJD-zb9PSY2AZ

It comes today and I will try to leave an update if it works. I know it's 5 meters but it's cheap.
Sorry for bad formatting I'm on mobile

Don’t know if this will help, see link

SCStyle 5 Meters GT2 2mm Pitch 6mm Wide Timing Belt for 3D Printer CNC https://www.amazon.com/dp/B00F2IQNX8/ref=cm_sw_r_cp_api_i_M2rkDbJV7HD75

Do you think this belt would work? I'd prefer to use amazon for the prime shipping.

On my machine, I have added the following upgrades:

• Inductive sensor for bed leveling
  
• Dual Mosfets
  
• Reinforced Belts
  
• Buildtak clone (optional)
  
• X and Y cable chains (optional)
  
• Y axis belt tensioner (optional)
  
• OctoPi running on a Raspberry Pi 3 B (optional)
  
• Semi-circular fan attachment
  
• Top Mounted Spool Holder (optional, not for heavy spools!)
  
  I hope this helps!
  

I'd say 8 months, PLENTY of printing. I only noticed it after rebuilding my printer with the Multi material mod, which required another run of the xyz calibration, which frustratingly it was not passing.
Very easy / cheep fix, 9 bucks on amazon for enough belt to replace both axis a number of times.
Unsure what specifically may have caused this failure, printer worked until I dissembled it, but they are bound to wear out eventually.

https://www.amazon.com/Meters-pitch-wide-Timing-printer/dp/B00F2IQNX8/ref=sr_1_2?ie=UTF8&qid=1502926845&sr=8-2&keywords=gt2+2mm+pitch+6mm+wide+timing+belt

4 meters sounds like it would be plenty, a parts site I found lists a 5 meter belt as a replacement for the x and y axis, so 2.5 meters seems like the length it's asking for, but I'm not sure how much leftover you'd get with that.

Before you try greasing anything, I would definitely recommend picking up a spare meter or two of GT2. It's not expensive nowadays, and you can get a crapton of it for ten bucks on Amazon.

Anyway, it could be a binding issue, but I'm not really sure. It really does sound like the noise of a belt popping off the roller and then snapping back in place though.