#323 in Lawn & garden watering equipment
Reddit mentions of Gilmour Brass x NH 807734-1001 Heavy Duty Hose Connector Double Female Swivel 3/4 inch, 3/4-Inch by 3/4-Inch
Sentiment score: 0
Reddit mentions: 3
We found 3 Reddit mentions of Gilmour Brass x NH 807734-1001 Heavy Duty Hose Connector Double Female Swivel 3/4 inch, 3/4-Inch by 3/4-Inch. Here are the top ones.
Buying options
View on Amazon.comor
For connecting threaded hose to hose.Premium construction for maximum strength and durability. Thread size swivel 3/4 inch National Hose Thread; 3/4 inch National Hose Thread.Manufactured using highest level of quality control.Solid brass connector.
Specs:
Color | Brass |
Height | 2 Inches |
Length | 6 Inches |
Number of items | 1 |
Size | 0.75 x 0.75 Inch |
Weight | 0.09 Pounds |
Width | 4 Inches |
this to this to this
of course you could just buy this
Most of the low-end electric pressure washers come with plastic connectors that attach your hose to the body of the washer. These usually leak water even if you use thread seal tape. To solve this problem, you should purchase some brass connectors off Amazon or your local hardware store. They screw on to your washer with one piece and another piece to your hose.
http://www.amazon.com/Gilmour-7FHS7FH-Double-Female-Connector/dp/B000FJYR5K/
^ This part would connect to the unit directly
http://www.amazon.com/Gilmour-09QCGT-2-Piece-Green-Connector/dp/B000BQS2I0/
^ One part would connect to your hose and the other would attach to the brass connector that's connected to the body of your washer. Make sure you attach it tightly and/or use thread seal since leaks may still occur but shouldn't if attached properly.
I use one of these to connect the male end of my hose to my spigot. The female end can then hook up to my plate chiller. Another hose on the out side of the chiller is hooked up and the male end ran to my sink.