#27,696 in Tools & Home Improvement

Reddit mentions of STEPPERONLINE 27:1 Planetary Gearbox High Torque Nema 17 Stepper Motor 3D Printer DIY Camera

Sentiment score: 0
Reddit mentions: 2

We found 2 Reddit mentions of STEPPERONLINE 27:1 Planetary Gearbox High Torque Nema 17 Stepper Motor 3D Printer DIY Camera. Here are the top ones.

STEPPERONLINE 27:1 Planetary Gearbox High Torque Nema 17 Stepper Motor 3D Printer DIY Camera
Buying options
View on Amazon.com
or
    Features:
  • High Torque Good Speed
  • 0.067 deg. Step Angle
  • NEMA 17 bipolar 4-wire
  • Planetary Gearbox Ratio 26.85:1
  • Rated current 1.68A & resistance 1.65ohms
Specs:
Height1.88976 Inches
Length1.65354 Inches
Weight1.26 Pounds
Width1.65354 Inches
Related categories:

idea-bulb Interested in what Redditors like? Check out our Shuffle feature

Shuffle: random products popular on Reddit

Found 2 comments on STEPPERONLINE 27:1 Planetary Gearbox High Torque Nema 17 Stepper Motor 3D Printer DIY Camera:

u/Ghandi720 ยท 1 pointr/Reprap

Thanks, am I supposed to invert the logic for the virtual endstops too? I haven't calibrated the steps/mm quite yet.

I can't even get my extruder motor to spin. I've tried adjusting my stepper to give it more amperage, but no luck. Do you know if it can put out enough to move one of these?

u/Tude ยท 1 pointr/AskElectronics

So a single step is fine, it's just microstepping that's the problem with respect to torque? Or do I have that wrong?

I'm looking at, say, this now, and it claims 0.067 degrees/step. So, that means that it would deliver a decent bit of its rated torque and only move .067 degrees if moved one step? Or should I be looking for an even bigger gear reduction to get that kind of behavior?