Reddit mentions: The best automotive drive shafts
We found 2 Reddit comments discussing the best automotive drive shafts. We ran sentiment analysis on each of these comments to determine how redditors feel about different products. We found 2 products and ranked them based on the amount of positive reactions they received. Here are the top 20.
1. TADD Replacement for Chevrolet S10 / S15 & GMC Sonoma Rear Driveshaft 1994-2003 2 Weel Drive 4.3 Liter Automatic Transmission
- Extended Cab Problem Solving CV Eliminator
- This NEW Driveshaft is complete, balanced and ready to install using your front section over.
- Dynamically high speed balanced for vibration-free operation
- Measures 46 3/4" from the face of the flange at rear end to end of the slip yoke that slides on to the splines near the center support bearing
- Includes slip yoke and rear flange
Features:
2. Complete Front 24" Driveshaft for Dodge Dakota 4x4 Models Only - [DR-10]
24" Overall LengthFor - 2001-2004 Dodge DakotaFor - 2005-2006 Dodge Dakota 4WD w/4 & 5 Speed Auto and 6/5 Speed ManualFor - 2007 Dakota 3.7L 4WD and 4-Speed Auto - [2006 Raider 4WD 3.7L 4WD and 4-Speed Auto + 6-Speed Manual]Engineered for superior durability, backed by industry leading warranty
Specs:
Height | 6 Inches |
Length | 30 Inches |
Weight | 13.11 Pounds |
Width | 6 Inches |
🎓 Reddit experts on automotive drive shafts
The comments and opinions expressed on this page are written exclusively by redditors. To provide you with the most relevant data, we sourced opinions from the most knowledgeable Reddit users based the total number of upvotes and downvotes received across comments on subreddits where automotive drive shafts are discussed. For your reference and for the sake of transparency, here are the specialists whose opinions mattered the most in our ranking.
I have a 96 ext cab 4.3v6 Auto that came with the two piece and double cardan. I was experiencing horrible noise and vibration and ended up replacing the carrier bearing and the double cardan half of the shaft with this unit from Amazon.
​
I've had it in there for over a year on a truck that's lowered 4" all around(pinion angle corrected). It's been on a few road trips totaling over a 1,000 miles and has seen plenty of runs up to the speed governor(95mph), sometimes holding 90mph+ for many miles.
​
My personal experience with it has been really great. I have no basis to a good stock unit but it was a dramatic improvement over the one I had in it. Vibrations and noise virtually zero and there seemed to be a difference in throttle response as well.
​
This was a direct bolt in and go. I changed it out over a couple hours in the driveway with some help.
​
If this place still insists on that price I would suggest replacing it yourself either with the unit I linked or a stock replacement.
Whole piece:
https://www.amazon.com/Complete-Front-Driveshaft-Dakota-Models/dp/B01MS0DRW5