Reddit mentions: The best counterbores
We found 3 Reddit comments discussing the best counterbores. We ran sentiment analysis on each of these comments to determine how redditors feel about different products. We found 3 products and ranked them based on the amount of positive reactions they received. Here are the top 20.
1. Accusize Industrial Tools H.S.S. Solid Cap Screw Counterbore Set, 3 Flute, Straight Shank, 7 Pc, 508S-0007
- High Speed Steel
- Straight Shank
- Inch Set (7 PC) : 6#, 8#, 10#, 1/4'', 5/16'', 3/8'', 1/2''
Features:
Specs:
Height | 12.204724397 Inches |
Length | 2.755905509 Inches |
Weight | 1.9 Kilograms |
Width | 9.448818888 Inches |
2. 7/8" Interchangeable Pilot Counterbore
High Speed Steel,Short SeriesStraight Shank
3. Drill America DEWCBR Series Qualtech High-Speed Steel Pilot for Counterbore, 3/16" Shank Diameter, 1-3/4" Length, 1/4" Size (Pack of 1)
Pilot for counterboreHigh-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance3/16-inches shank diameterAvailable in 1-3/4-inches overall length1/4-inches size
Specs:
Number of items | 1 |
Size | 1/4" X 3/16" |
Weight | 0.0220462262 Pounds |
🎓 Reddit experts on counterbores
The comments and opinions expressed on this page are written exclusively by redditors. To provide you with the most relevant data, we sourced opinions from the most knowledgeable Reddit users based the total number of upvotes and downvotes received across comments on subreddits where counterbores are discussed. For your reference and for the sake of transparency, here are the specialists whose opinions mattered the most in our ranking.
These counterbore sets are great to have around, and the old-school factor is definitely cool; however, this particular set would only be worth it if the price is around $150-$200
The fact that you can swap out pilot tips isn't actually very useful (in my case at least) because the fixed pilot counterbore sets are all made to standard and metric screw sizes already. You can pick up a new counterbore set of standard and metric for a total of ~ $100. I picked mine up from amazon here here and
here
its not hard. youll need a drill for the through hole and a 7/8" counterbore. Just take small steps and measure to make sure you dont over shoot the depth.
https://www.amazon.com/7-8-Interchangeable-Pilot-Counterbore/dp/B008RYUQLY
Like this one (but you will need the correct pilot for the though hole)
A countersink is an angle. A flat bottom is a counterbore.
You can buy a cutter the size of your outer diameter, and a pilot the size of the inside.
Frankly, I would suggest simply trying to do it with plain old twist drills. Once you put the screw in you wont be able to tell the difference.