Reddit mentions of Iron Wing-Head Thumb Screw, M6 x 1mm Thread Size, 30mm Long

I have some big plans for these two, but part of those plans involve integrations. I do have modifying experience with epoxy putty, removing ARs, switching springs, and more, but I've never combined shells before.

Here's what I'm thinking about doing with these blasters.

.


For the Slingfire I want to give it metal gears, a 9 kg spring, a thumbscrew for the stock, and a detachable long brass barrel so the whole thing can fit in a smaller bag.


I think I'll cut off the shell's "barrel" entirely and remove the flat feeder mechanism. I'll cut the new barrel attachment piece down so that the recon barrel is flush when it's attached. I'm debating if I should just keep the attachment whole and glue it to half the shell, or cut the attachment in half and glue each half to a different shell half.


.


The Ball launcher will be more tricky. What I might try is either replacing the elastic with a better one or just switching it out entirely with some kind of wire and pull spring set up. I think there's real potential in the tennis ball launcher. I just haven't found anybody that was willing to spend the time to experiment with its internals.

I think to make the stock attachment work I'll cut a recon's attachment point from its shell and glue the two halves to the tennis ball launcher shell. I'll probably drill long screws and stuff some epoxy putty in it as reinforcement.

.

I hope that what I said makes sense and that anybody cares enough to read it.