#18,560 in Tools & Home Improvement
Reddit mentions of Freud 3/8" Radius Round Nose Bit with 1/4" Shank (18-112)
Sentiment score: 1
Reddit mentions: 1
We found 1 Reddit mentions of Freud 3/8" Radius Round Nose Bit with 1/4" Shank (18-112). Here are the top ones.
or
Cuts all composition materials, plywoods, hardwoods, and softwoods.Use on CNC and other automatic routers as well as hand-held and table-mounted portable routers.Kickback reducing designIndividually computer balancedPrecision ground for the smoothest cutsCovered by Freud's limited lifetime warranty
Specs:
| Color | Perma-SHIELD Coating Red |
| Height | 1 Inches |
| Length | 1 Inches |
| Number of items | 1 |
| Size | Pack of 1 |
| Weight | 0.09 Pounds |
| Width | 1 Inches |
You wouldn't need a bit that would remove all the material, necessarily. You could use an edge guide and a straight-cutting bit to remove the center of the material. Then you could use a template for the full width and a round-nose router bit to do the edges of the cove. I can't find a link to the profile I'm thinking of to clean up the sides, but they're out there. I don't know how big that cove is, but this router bit might do it?
You can also look up setting up your table saw to cut a cove, but I suspect that wouldn't give you the results you want, as the stock is smaller and the cove is stopped and relatively deep compared to the width of the stock.
Good luck!