#15,447 in Tools & Home Improvement
Reddit mentions of Heavy Duty Adjustable Furniture Leg Levelers, Small Foot Ideal for Tables, Shelving Units, Shop Cabinets and Furniture (4 Leveling Legs)
Sentiment score: 1
Reddit mentions: 1
We found 1 Reddit mentions of Heavy Duty Adjustable Furniture Leg Levelers, Small Foot Ideal for Tables, Shelving Units, Shop Cabinets and Furniture (4 Leveling Legs). Here are the top ones.
or
- If you have ever built or owned a desk, table, cabinet or even a bookshelf that once sat perfectly on your floor only to become wobbly after a while, then you know how frustrating it can be to fix. While we could always use the old stacked pieces of cardboard trick, we all know that wont last very long. The Fulton Leg Levelers solve this issue and also make workshop cabinet and workbench leveling a breeze.
- Once installed, you can adjust the height of each corner without having to dangerously reach under the furniture. All you need is the included hex key wrench. Simply insert the hex key wrench into the top of the leveler stud and rotate the bolt to adjust the installed leg leveler up and down. Check you furniture piece to make sure its not rocking and you’re all set.
- The Heavy Duty Leg Levelers have an L-shaped mounting bracket made from a heavy gauge, plated steel that hook onto the bottom edge of you cabinet for excellent support and stability unlike standard levelers that only allow access from the bottom and also require a knuckle busting wrench to make adjustments. The unique design of the leg leveler allows for easier access to the adjustment bolt. This allows you to micro adjust each leg until they are perfectly level to your desired height. .
- The large 1-1/2" diameter heavy duty, polyethylene foot will protect your floor and block any moisture from getting to the foot. No more rust spots left on the floor surface like most common, underneath access levelers leave behind.
- The adjustable legs have a 10mm dia. (apx. 3/8") shaft that adjusts from 0" to 2" in height. Using all four levelers provides you with a total load capacity of approximately 600 lbs. Easy to adjust with the included Hex Key Wrench.
Features:
Specs:
| Weight | 1.1 Pounds |
I had prepared for the floor by ordering some leveling feet. I got a set for each side, but realized during the build that really only the front legs needed the leveling, so 1 set of 4 was enough.
I used these which were plenty strong enough: https://www.amazon.com/dp/B06ZXSXL5Z/ref=cm_sw_r_em_apa_i_.U20Db75Y4MWK
Unrelated to the floor, but the one mistake I made was counting on the back wall to be a reliable reference, and so when attaching the two sides to the miter platform I didn't take the time to square it up perfectly, and so there is an ever slight bow to it. Not a big deal, its a large enough surface, but it did ruin my plans to use the front as a reference to route out the slots for the t track since if I did it wouldn't be straight across the whole bench. I worked it out, but it just added a complication. So just make sure you square both halves more diligently than I did.