#2,773 in Industrial & Scientific
Reddit mentions of PneumaticPlus PC-1/4-N1 Push to Connect Tube Fitting, Male Straight - 1/4" Tube OD x 1/8" NPT Thread (Pack of 10)
Sentiment score: 1
Reddit mentions: 1
We found 1 Reddit mentions of PneumaticPlus PC-1/4-N1 Push to Connect Tube Fitting, Male Straight - 1/4" Tube OD x 1/8" NPT Thread (Pack of 10). Here are the top ones.
or
Body Style: Male Straight1/4" Tube OD x 1/8" NPT ThreadFluid Type: Air OnlyApplicable Tube: Polyurethane and Nylon
Specs:
| Number of items | 10 |
The tip is sold at home depot and lowes, probably Menards too, haven't checked their welding stuff before.
To connect it you'll want something like this along with some PTFE tubing of corresponding size. Screw the fitting into the gun, dismantle where the whip enters the box, cut the cable ties on both ends of the bundle, feed the PTFE tubing from one end to the other. Push the tubing into the connector on the gut. For the other end figure out a bulkhead to go from PTFE to a hose barb.
PTFE and Push-To-Connects may not be the correct choice either, you may be better off with a Vinyl tubing and a barb or compression fitting. I haven't done the conversion yet, so I don't know.
But if you're selling stuff to a customer, I'd recommend getting at least a good import machine like the new Alpha AHP MIG or the Everlast Power I-MIG series of welders.
As far as the tank goes, make sure it isn't a rental before you celebrate too hard, and make sure it's C25 or argon before hooking it up to anything.