#4,580 in Tools & Home Improvement
Reddit mentions of BLACK+DECKER LDX172C 7.2-Volt Lithium-Ion Drill/Driver
Sentiment score: 2
Reddit mentions: 5
We found 5 Reddit mentions of BLACK+DECKER LDX172C 7.2-Volt Lithium-Ion Drill/Driver. Here are the top ones.
Buying options
View on Amazon.comor
- Lithium Ion Battery - Always Ready, holds a charge up to 18 months
- Keyless chuck for quick and easy bit changes
- Mid-handle design for balance and control
- Chuck Size: 3/8 in; Included Components: LDX172 7.2V Lithium Drill/Driver, (1) Charger, (1) Double Ended Bit; Power Source: Cordless
- Lithium Ion Battery - Always Ready, holds a charge up to 18 months
- Keyless chuck for quick and easy bit changes
- Mid-handle design for balance and control
- Fan-cooled motor extends drill life
- Two drill speeds plus forward/reverse assure the right speed for the job
Features:
Specs:
Color | Orange/Black |
Height | 7.688 Inches |
Length | 8.313 Inches |
Number of items | 1 |
Weight | 0.3527396192 Pounds |
Width | 2.625 Inches |
After sanding down my pans I can tell you that I would never want to do it by hand. It would probably take you hours and hours of sanding.
Might be better off asking a friend or relative if you can borrow their sander for a day.
Or if a drill is more in the realm of something doable, I linked to some stuff in an earlier comment.
> If you want to go with another method outlined here you can use a regular drill. Tons of uses for a drill other than sanding down your skillet.
> Drill $30
> Coarse Wire Brush attatchment $9
> * Fine Wire Brush attatchment $6
> Total of $45
A drill! So very practical of me.
Or how about a dart board
Get this instead. Black & Decker LDX172C 7.2-Volt Lithium-Ion Drill/Driver https://www.amazon.com/dp/B005LTNLDI/ref=cm_sw_r_cp_awd_Z-pRwb9BYDFSK
I've been using probably the same General Precision Screwdriver as you for awhile now and it works great for most small screws. There are a few that require a bit of a wrist flick to loosen. I havn't broken it yet but I was lucky to get this PLUS the General Cordless Engraver for $10 for both so not a big deal if it gives out.
For larger screws I either use a Black and Decker 7.2v Lithium Cordless Drill (very lightweight but powerful) OR a Ryobi Tek 4 Cordless Screwdriver (a bit heavier but has light on the chuck, removeable rechargeable battery, and a '2' speed setting for quick removal of loose screws).
> normal household hammer drill.
This is a 'normal household drill'. It is not a hammer drill.