Reddit mentions of Turtle Wax T-223 Super Hard Shell Paste Wax - 9.5 oz (Pack of 1)

No problem.

https://www.amazon.com/Turtle-Wax-T-223-Super-Shell/dp/B000BPSVJ6/ref=sr_1_1?ie=UTF8&qid=1502586791&sr=8-1&keywords=turtle+wax

Easy to use. Just get the applicator pad a little wet, dab a little wax onto it, and apply it to the entire screen (just dont go into the microphone or speaker holes). Then give it a few minutes so it hazes over and dries, and then buff it out with a cloth. I usually did two or three coats but one is normally good. And it helps cover up very minor scratches too.

You can try simply waxing the surface of the board and adding pads to the bottoms of the strikers.

I use Mother's pure carnauba wax (amazon), same as on my crokinole board. The maker of Muzzie's crokinole boards recommends Turtle Wax super hard shell paste wax instead (amazon).

1. Rub a small amount on the board (do only a quarter of the board at a time otherwise the wax will harden on the surface in patches while you do other sections).
   
2. Use a buffing/microfiber cloth to spread the wax evenly in circles. The surface will become a little cloudy.
   
3. Important: after the whole board is waxed wait at least 20 minutes for the wax to cure.
   
4. Use a different side of the cloth to buff the wax off. Note that this whole process seems to work best in hotter temperatures.
   
   Under the strikers I put teflon stickers (amazon). Other people seem to have good results with Scotch felt pads instead (amazon).
   
   I did this to a new-ish board with two coats of wax and the striker movement was so slick, the game was difficult to play until the surface got some wear. The results won't be so dramatic with a well-worn board, but it goes to show that a bit of waxing will make a difference.

I used a lithium silicate sealer and carnauba based wax. I think it's a more durable, longer lasting finishing system than anything oil based. Oil also darkens the colors. The sealer and wax won't change final color.

​

Sealer:

https://concretecountertopsupply.com/Item/FishLithiumGal

​

Wax:

https://www.amazon.com/Turtle-Wax-T-223-Super-Shell/dp/B000BPSVJ6/ref=sr_1_29?keywords=carnauba+wax&qid=1565364222&s=gateway&sr=8-29

You should use some pure carnauba wax on the boards. Most people recommend Mothers. https://www.amazon.com/Mothers-05550-California-Brazilian-Carnauba/dp/B0002U2V1O/ref=sr_1_1?ie=UTF8&qid=1483199201&sr=8-1&keywords=mothers+pure+carnauba+wax

I got my board from Muzzies, and Murray suggested that I use https://www.amazon.com/Turtle-Wax-T-223-Super-Shell/dp/B000BPSVJ6. It's a blend, and he finds it works best on his surface.

5.95 for a can. Turtle Wax is soo generous.

If anyone has lots of scratches/defects in their paint, here are a couple steps that really make a huge difference for a total of ~$25:

• Wash car with Meguiar's Gold Car Wash ($7)
  
• Apply Meguiar's Ultimate Compound ($14) which will clean and polish your paint job and remove scratches/oxidation.
  
• Wax paint with Turtle Wax ($6) to get a clean shine and protection against the elements
  
• Buy some Mother's Back-to-Black Plastic & Trim Restorer ($8) and use to restore plastic trim to something closer to its original condition.