(Part 2) Reddit mentions: The best automotive fuel pumps & accessories

For black/gray water offloading, I'd look at a sewer bladder vs. moving the whole rig. I had one made and it comes in about 100g. They can make them larger, though. Check it out here:

https://learntorv.com/sewer-bladder/

​

For bringing water back, you can use an AQUATANK2 bladder. They come in a variety of sizes.

https://learntorv.com/aquatank2-water-bladder/

​

As mentioned, getting A/C is going to be the hardest nut to crack. My toy hauler has 2 x 40g gas tanks and a built-in Onan 5500. It supposedly uses 1/2g / hour of gas but I haven't actually measured/checked. We don't tend to run it 24x7 unless we really need to so a tank of fuel lasts us a while. Filling from 5g containers into the toy hauler is pretty miserable, but I just found this gas can fuel pump that I'm hoping to get + try soon. For your needs, I might see if I could get an auxiliary tank so you could refill at one go.

Consumable like how you replace fuel filters every xxx hours.

WIX Filters - 24744 Heavy Duty Fuel (Complete In-Line) Filter, Pack of 1 https://www.amazon.com/dp/B001Q8HF2Q/ref=cm_sw_r_cp_apa_i_mHBBCbB4Q1AHJ

I had a similar situation, and I too thought it was the gas cap. It ended up being the Fuel Vapor Leak Detection pump (believe it or not). The DME code I got was a 3220 DMTL, and a 3221 DMTL, which is the Hex code my program gives me. P1434 and P1447 are the relative DTC codes if that's how your reader shows it.

On my 2011 335i, it is located driver side rear, behind the wheel and next to the exhaust. I ended up buying the part on amazon and replacing myself. Probably took 40 minutes from start to finish, not knowing exactly what I was doing.

Hope this points you in a helpful direction!

you're on the right track, and EFI tank with internal baffling is the best way to go. but i'm not sure who makes them for the second gen f-bodys. but i think Spectra makes them, they talk about it here: http://www.nastyz28.com/forum/showthread.php?t=265374

EDIT: http://www.amazon.com/gp/aw/d/B00F4TTVIE?pc_redir=1410495248&robot_redir=1

See: https://www.amazon.com/CUSTONEPARTS-Electric-Intank-Module-Assembly/dp/B073SRQKSL

Notice how the sock for the pickup sits below the actual pump? It doesn't have to run out of fuel for the pump to be exposed to air (in this particular case). Also in what vehicle is the pump after the filter? Genuinely curious.

buy the same one again and get a spare to carry in the car. if you ever need to change your fuel pump get the original style pump for a 65 with the big integrated cartridge filter. https://www.amazon.com/Carter-M4009-Mechanical-Fuel-Pump/dp/B000BZZ6S0/

Which brings me back to the original question: Should I install a centrifugal pump(1hp, $535) or a vane pump(3/4hp, lower flow, $950)?

The fuel pump/sender assembly?

https://www.amazon.ca/Spectra-Premium-SP333H-Assembly-Sending/dp/B000C7S5IA/ref=sr_1_7?keywords=ranger+fuel+pump&qid=1556108548&s=gateway&sr=8-7

Let me inventory my stuff. I know I have two FD-4606 filters...but I don't even know what those are for. I think they're for the 6.2l?

I'm going through my stuff, i'm running the part numbers to see what I have

EDIT: I have these, which I believe is what you are referring to? If it is, PM me.

http://www.amazon.com/Wix-33518-Fuel-Filter-Pack/dp/compatibility-chart/B000C9TBEA

https://www.amazon.com/Delphi-FE0115-Electric-Fuel-Motor/dp/B000CGFUHK/

vs

https://www.amazon.com/Delphi-HP10041-Hanger-Assembly-Sending/dp/B001FIR7Y8/

Assuming 3/8" line, put this in a place where the line is not going to move or be tugged on much. WIX Filters - 33003 Fuel (Complete In-Line) Filter, Pack of 1 https://www.amazon.com/dp/B000CSEUPG/ref=cm_sw_r_cp_apa_LsYKyb6QYQ9JQ

This is the one I used to replace my "primary" one.

The mikuni triple? Does this work?

Fox Distributing DF52-92 Mikuni Triple Fuel Pump https://www.amazon.com/dp/B00336EBGW/ref=cm_sw_r_cp_apa_i_FQumDbQM1VYC4

You sir, are correct http://www.amazon.com/Edelbrock-3581-High-Pressure-Electric-Fuel/dp/B00062Z2SM

http://www.amazon.com/Delphi-FG0938-Fuel-Module/dp/B008NAGQHK

is this a scam? advance auto's cheapest full assembly for my car is 800 bucks..

Not sure where you're shopping, but I found a fuel pump for your car that costs 33 bucks and 33 cents, shipped and handled for free.

Sorry thought the link in the title would work more pictures here. I purchased this replacement.

Had this problem a couple of weeks ago. I thought it was the o-ring but there was actually a small crack on top of the thing. I used epoxy to seal it and it hasn't leaked since.

This would probably fix your problem tho
https://www.amazon.com/dp/B01FKA8DIK/ref=cm_sw_r_cp_apa_i_VWxIDb0MH5YDR

Yea it's one that screws onto the gas tank and is designed for it. https://www.amazon.com/dp/B01IWCP7XC/ref=cm_sw_r_other_apa_i_vzzXDb77NBMAZ

Actually, I lied - I got it off Amazon.